It is a high-quality enamel with a modified silicone resin base, which allows you to renew all surfaces normally exposed to high temperatures. Heat resistant up to 300°C-700°C. It’s ideal not only for products found at home but the steel industries, auto body repairman and forge industries. Fields of Application: : Metal surfaces as iron, aluminum, steel, parts of heaters, stoves, ovens, chimney flues, barbecues, fire screens, motorcycle mufflers, steel industries, auto body repairman and forge industries. Instructions for Use: Use gloves and mask before application. Avoid contact with skin and eyes. Apply in well-ventilated areas. Do not breathe its vapour. Shake the can by hearing the mixing ball loudly for 1 minute. It is also suggested to occasionally shake the cylinder even during use. To obtain an optimal and long lasting result it is necessary for the painted parts well dried in depth, to be exposed for a few minutes even if only once, to a temperature of at least 180°C; any less will make the hardening and adhesion of the enamel only partial. Carefully clean the surface before application. Test in a hidden area to verify compatibility of the surface with the paint. Remove the security seal on the cap, to open the spray. Apply a first hand/coat light to improve coverage and adherence, to reduce the possibility of dropping. Apply from a distance of 20-30 cm. After a few moments apply a second horizontal hand/coat immediately followed by a third vertical hand/coat. Let dry for a few minutes. After use, it’s advisable to spray for 2/3 seconds with the spray upside down, to avoid the block of the actuator; It is dry to the touch approximately 15 minutes after use and it's completely dry approximately 22 hours after application. Store the product in a cool and dry place. Keep out of freezing, direct sunlight and temperatures above 50°C. Keep out of reach of children.